Amtico flooring is just about the most hardwearing and practical alternative to real wood.
A huge selection of Amtico flooring in the latest natural wood designs that are available These range from the softest grains such as white maple, to the mid toned classic oaks, and on to the darkest colour in our range Wenge Wood.
All Amtico woods are genuine British made commercial grade (not the Asian made Spacia or Karndean) and are manufactured in ‘tick’ finish in the standard 114mm x 915mm standard size.
Choosing an Amtico floor means you don’t have to worry about long term maintenance- your floor will never need sanding or re-finishing. The tough hardwearing surface will repel stains and moisture making it an ideal choice for wet areas such as bathrooms and shower rooms, and heavy wear areas like hallways and entrance lobbies.
Amtico wood authentically replicates the natural product and it’s true characteristics. The Stripwood is highly variable in grain and decoration. Please consider this in your product choice as online images only display a small section of the material.
Installing Amtico wood flooring can be undertaken by any reasonably competent DIYer with little in the way of equipment. If you are laying onto an existing wood floorboard, chipboard, or MDF sub-floor, it is always good practice to install a new plywood base first. This ensures long term wear, it will also prevent undulations showing through your new flooring.
If your sub-floor is reasonably flat, 6mm exterior grade moisture resistant plywood is adequate. This should be fixed at 15-20cm centers with screw nails. If your sub-floor is old and extremely uneven, a thicker grade plywood 9mm or 12mm should be used. However before fixing this, level off any hollows with a latex screed compound. Otherwise the plywood will never be completely flat.
After installing the plywood, spend as much time as possible filling any gaps in the joints, and knocking down nails flat. Then take down any high spots with a medium grade sand paper. More Time taken on preparing the sub-floor will produce huge dividends when you have installed you new Amtico, so do not be tempted to cut any corners.
Depending on how flat and smooth you have managed to make the prepared sub-floor, it may be necessary to apply a further leveler such as Ardex “Feather Finish” which can be applied thinly without the risk of de-bonding
When you are installing over a solid floor e.g. concrete, asphalt, quarry tiles, stone flags etc. it is important that your do a thorough check of the moisture content of the sub-floor. Even a minute amount of moisture in a sub-floor will cause Amtico flooring to start lifting within a very short period of time. Your investment will then be wasted, as the floor will be beyond repair.
Check in the first instance for the presence of a dpm, which should be visible on your outside, walls maybe the first or second line of brick or stone. If there is none evident, and your house was built before 1960, then it is wise to assume that there is no damp proof membrane in the sub-floor.